TTGO T-Beam display brightness?

[dk7td]

Hi,

I'm using a TTGO T-Beam with MySondy Go and it's running fine. The only issue is the very dim display, so I can hardly see outside, if it's powered on or off.
Is there any way to change the display brightness? With other software (such as RDZsonde) everything was fine. But I prefer MySondy Go

Thanks!

[dk7td]

Crazy but true - I found a solution for my issue:
I flashed the T-Beam back to RDZsonde and then again to MySondy Go - and everything is ok ...

[dk7td]

Hmmm ... next time I powered the T-Beam up, it was dim again. Any idea?
Thanks!

[IZ4PNN]

Hello,
the brightness of the display in the T-Beam is regulated by a special energy management circuit which is not present in the TTGO.
In addition to this from our tests carried out the T-Beam is a little "deaf".
For these reasons MySondy GO is compatible with the T-Beam but the T-Beam is not officially supported.
A work around could be to power the display directly.

[dzaring]

What settings did you use to get you T-Beam to work? I've tried several setting and just get errors.